How To Use A CenTech Digital Multimeter

This page identifies How To Use A CenTech Digital Multimeter and how to charge rx batteries. Visit How To Charge rx batteries for additional resources and information.


Posted on

Mute the speaker Listen to this using a male or female voice M/F 

By Kurt Schanaman

The Cen-Tech multimeter is an inexpensive digital multimeter solution with all of the basic functionality found on any other competing brand. The Cen-Tech multimeter is capable of accurately measuring alternating current voltage (ACV) as well as direct current voltage (DCV). The meter also allows the user to test the amount of resistance in a...

1

Mute the speaker Listen to this using a male or female voice M/F Stretch out the two test probe wires next to the meter, doing so for both the red, positive (+) and the black, negative (-) probe wires. Make note of the metal ends of each wire. The short metal appendages are the plugs which slide into the jacks on the front panel of the multimeter, and the long, narrow appendages are the test probes which are touched to the circuit or component being measured.

2

Mute the speaker Listen to this using a male or female voice M/F Insert the plug of the black, negative (-) wire into the "COMM" jack of the multimeter, and insert the plug of the red, positive (+) wire into the "10ADC" jack to measure either AC or DC voltage. If measuring resistance or amperage, insert the plug of the red wire into the jack labeled "V(ohm)mA" jack instead, where the word "ohm" is actually the Omega symbol, a horseshoe-type emblem.

3

Mute the speaker Listen to this using a male or female voice M/F Turn the multimeter dial from "OFF" to the "ACV" section of the meter if measuring AC voltage, or "DCV" if measuring DC voltage. For these two, keep the red plug inserted in the "10ADC" jack. If you want to measure amperage rather than voltage, move the red wire plug to the "V(ohm)mA" jack and then move the meter dial to "DCA" (DC amperes) for measuring DC amps, or turn the dial to the "10A" position if measuring AC current amps up to 10 amps total.

4

Mute the speaker Listen to this using a male or female voice M/F Plug the red wire plug into the "V(ohm)mA" jack and set the dial to the panel section with the Omega symbol in it for measuring resistance in "Ohms."

Share on Facebook Share on Twitter Email Gmail Yahoo! More...


Charging Rx Batteries

 Neverdie Comparison Sheet
FREE Rx Battery Charging Guide
 Battery Rxtm
FREE Rx Battery Charging Guide
 Charging The Battery Mounting And
FREE Rx Battery Charging Guide
 Operating Manual Ranger Rx
FREE Rx Battery Charging Guide
 Instruction Manual
FREE Rx Battery Charging Guide
 Battery Charger
FREE Rx Battery Charging Guide
 Rx Series Motive Battery Chargers
FREE Rx Battery Charging Guide
 Cr 2500
FREE Rx Battery Charging Guide